Scribd
Upload
127 views

SIMCGA

This utility allows software requiring a Color Graphics Adapter to instead use a Hercules monochrome adapter. It reproduces graphics images in normal aspect ratio using the available screen area. It programs the Hercules card to display more lines of three lines per character time instead of four, copying one line to the third displayed line to fill it out. This results in some color grayscaling but causes minor ghosting on moving images and can affect small line details. It may not properly support CGA register reads or the 40x25 text mode. It has been tested to work with several programs without issues.

Uploaded by

zarcelo
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
127 views

SIMCGA

This utility allows software requiring a Color Graphics Adapter to instead use a Hercules monochrome adapter. It reproduces graphics images in normal aspect ratio using the available screen area. It programs the Hercules card to display more lines of three lines per character time instead of four, copying one line to the third displayed line to fill it out. This results in some color grayscaling but causes minor ghosting on moving images and can affect small line details. It may not properly support CGA register reads or the 40x25 text mode. It has been tested to work with several programs without issues.

Uploaded by

zarcelo
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

SIMCGA - Simulate CGA with Hercules Monochrome Card Written in September 1986 by Chuck Guzis 153 North Murphy

Ave. Sunnyvale, CA 94086 This memory-resident utility allows you to "fool" most software requiring a Color Graphics Adapter into using your Hercules (or compatible) monochrome adapter in the graphics mode. Graphics images are reproduced in normal aspect ratio, using as much of the available screen area as is possible. The trick used here is to program the HGC to display more lines of 3 lines per character time instead of 4 (The CGA displays 2). A service routine hooked into the hardware timer interrupt (int 8) copies one line to the third displayed line to give a filled-out image. The method used here works and results in some useful color gray-scaling, but it does have a few minor drawbacks 1. Since the copy operation occurs in real-time concurrent with the display, some "ghosting" on moving images is inevitable. 2. Since the image is expanded vertically by 1/2, small line details will be affected by the line doubling technique. This is mostly an aesthetic annoyance. 3. Those utilities which "read" the CGA registers at 03d4 et seq. are going to find no registers to read. This does not seem to affect many programs. 4. 40x25 text mode is not supported - the hardware just isn't there. This mode is mapped into 80x25 and again, doesn't seem to bother many utilities. 5. When in text mode (modes 0, 1, 2 and 3), the normal monochrome character attributes are not available - this is a problem with the way the HGC handles the attribute memory map. Quite a few programs have been tested, including Flight Simulator, PC-CAD, BASICA and some games with no hitches. This package contains three programs - SIMCGA, SETCGA, SETMONO. SIMCGA is the memory-resident part and must be run before the CGA simulation feature is available. SETMONO will restore the monochrome-only mode; SETCGA will reset CGA compatibility after a SETMONO. If this feature is used routinely, you might want to put this in your AUTOEXEC.BAT file SIMCGA SETMONO and then run a SETCGA when you need the CGA feature.

You might also like