Scribd
Upload
146 views3 pages

Efm Dual Adsr

This document provides assembly instructions for a dual ADSR envelope generator circuit board. It consists of: 1) Instructions for assembling the circuit board components which include installing resistors, IC sockets, capacitors and soldering header pins. 2) Mounting the assembled circuit board to the front panel and wiring the panel components. 3) Notes that LEDs are no longer used and faster envelopes can be achieved by changing resistor values.

Uploaded by

Anonymous vKD3FG6Rk
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
146 views3 pages

Efm Dual Adsr

This document provides assembly instructions for a dual ADSR envelope generator circuit board. It consists of: 1) Instructions for assembling the circuit board components which include installing resistors, IC sockets, capacitors and soldering header pins. 2) Mounting the assembled circuit board to the front panel and wiring the panel components. 3) Notes that LEDs are no longer used and faster envelopes can be achieved by changing resistor values.

Uploaded by

Anonymous vKD3FG6Rk
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

DEG 2a - Dual ADSR

Dual ADSR Envelope generator. Features...


G G

Common Gate +/-12 or +/- 15V

Assembly
G G G G G G G G G G G G

Press the overlay on the panel blank Drill and clean the holes Remove the application tape and cutouts Mount the jacks, switches, pots ect... to the panel. Install the resistors Install the IC sockets Install the capacitors Cut and solder header strip pins in pads used to connect wire to the board Plug the ICs into their sockets Mount the L-Brackets to the board with 440 screws and nuts, using the non threaded end of the bracket Mount the board to the panel with 440 screws using the threaded end of the bracket Wire the panel mounted parts to the header pins.

Notes
G G G

D3 and D6 are mounted to the control pots. Do not install them on the pc-board. The LEDS are no longer used you can also omit R12 and R17. For faster envelopes change R9,10,11,14,15 and 16 from 1K to 100ohms. Change C6 and 8 from 10uF to 4.7uF

Schematic

PC Board

PC Board Wiring

Small Parts Kit C1,C2 C3,C5,C7 C4 C6,C8 R1,R2,R5 R3,R8,R13 R4,R6 R7 R9-R12,R14-R17 D1-D8 Q1-Q3 U1 U2 PC-Board Full Parts Kit P2, 3, 4, 6, 7, 8 P1,5 Knobs Panel 8 pin 14 pin J1 L-Bracket J2, J3 1/8th Power Connector 1M 10K 0.1uF 0.01uF 100uF 25V 10uF 16V 10K 4.7K 2.2K 100 1K 1N4148 2N3904 LM556 TLO72 2 3 1 2 3 3 2 1 7 8 3 1 1 1 6 2 8 1 1 1 1 2 3

You might also like