-

Module 07
1. The Sallen Key filter - Second order filter 2. The drain current in the current circuit when constant current area increases. - The gate to source bias voltage decreases 3. Semiconductor is reversed bias with large enough voltage will conduct, this is because of - avalanche effect 4. T-MOSFET is a kind of - EMOSFET 5. Difference between SCR and SCS - Has two gate terminals 6. Which of the following characteristics does not necessarily apply to op-amp? - Low power 7. A phase shift through op-amp is because of - Internal RC circuit 8. A FET does not has - Forward biased PN junction 9. An operational amplifier must have at least how many usable terminals? - 5 10. Generating a voltage in a generator will likely to happen only when - There is relative 1 motion between conducting wire and magnetic line of force. 11. Two essentially parts of rotating generator. - Electro/permanent magnet and armature winding 12. Generally a DC generator - The armature winding is rotated with respect to a magnetic force produced by electromagnets or permanent magnets. 13. A junction of two conductors that exhibits electrical characteristics during changing temperature condition. - Thermoelectric conduction 14. How does electric field in JFET established? - By the presence of charge at gate terminal during reversed bias. 15. Relaxation oscillators are based on - By charging and discharging of capacitor 16. Load regulation

17. 18.

19. 20.

21. 22.

23.

24.

Changing load and output voltage remains constant Transient suppression minimized the chance of - Diode failure If two waves, have the same frequency and the same phase, the composite wave is equal to: - Magnitude of the sum of two original waves The current consists mainly of holes when a JFET - Has P type channel A basic isolation amplifiers has 3 electrically isolated parts - Input, output, power The most important transistor characteristic curve - Output characteristic curve In a voltage divider bias npn transistor, what happen when the resistor on the higher place opens? - The transistor goes to cut-off Which statement is true about alternator? - High speed alternator is smaller than the lower speed What is the used of noise generator? - Evaluating the noise characteristics of an amplifier. - make the feedback and input resistances as smaller as possible. What is the purpose of current limiting in regulators? - To protect the regulator from excessive current. In power distribution, the most commonly used insulator - Porcelain In Zener diode, when the zener voltage is 3.6 V - Zener breakdown The realistic open loop gain - 100, 000 When frequency of the open loop gain is equal to 1. - Unity gain frequency Phase shift of the ac sine wave by 90 degrees is the same as the - Rotating from left/right by cycle In RL circuits, the ratio of XL/R decreases, phase angle - Decreases Common-base configuration application - Radio frequency power amplifier Found at the output of the op-amp - complementary amplifier SCR differs from four layer diode

25.

26. 27.

28. 29. 30. 31.

32.

33. 34. 35.

36. 37. 38. 39. 40. 41.

42.

43.

44.

45.

46.

47. 48.

49.

50. 51.

52.

- It has gate terminal Differrence between SCR and SCS - Has two gate terminals Air works weel as dielectric because - It has low loss The use of I layer in PIN diode - Minimize the diode capacitance TMOSFET is a kind of - EMOSFET Which FET has a wide and short effective channel - VMOSFET A circuit used for voltage equalization during on-off switching actio of SCRs in series - Snubber circuit The external resistor of instrumentation amplifier is used to - sustain voltage gain The low pass is cascaded to he high pass filter, the critical frequency of the low pass filter is - Greater than the critical frequency of the low pass filter The most popular op-amp packages are the metal can, 8-pin DIP, the SMT. Which of the following corresponds to TO-99? - Metal can The magnitude of the op-amps input offset voltage before it can be classified as a low input offset voltage op-amp. - 0.2 mV High voltage is used in long distance power transmission because - The I2R losses are lower The forward breakover voltage of a silicon diode is - About 0.6V Which bipolar amplifier type has same distortion in the signal wave, with collector current during the most, but not at all of the cycle - Class AB2 The frequency at which the crystal oscillator functions is determined mainly by - The thickness of the crystal In an AND gate the output is high - Only when all inputs are high In an Exlusive OR gate the output is high - Only when the inputs have opposite logict states What type of generator consists of a single coil rotated in a magnetic field?

53. 54.

55.

56.

57. 58.

59. 60. 61. 62.

63.

64.

65. 66. 67.

68.

69.

- Elementary generator Which does not affect the inductance of the coil - Diameter of the wire When two or more generators are applying a common load - Parallel generators An early version of the field effect transistor in which limited control of current carriers near the surfaemof a semiconductor bar or film was obtained by an external field applied transversely - Fieldistor A push-pull amplifier that uses npn and pnp transistors to amplify the positive and negative cycles respectively - Complementary symmetry amplifier The freuency at which open loop gain is equal to one - Unity gain frequency Which of the ff. is does not have an output terminal of a 555 timer? - Clock In an OTA transconductance varries with - Bias current The efficiency of a class AB amplifier is - Slightly less than class B When choosing dc motor - Speed-tourqe It is a modified version of wheatstone-bridge, it is used to measure low resistances - Kelvin Double bridge Simplified wheatstone bridge, the ratio arm is replaced by constant time of uniform cross section exactly 100 cm long - Slide wire bridge Used to measure the impedance of both inductance and capacitance at higher frequencies - Radio frequency bridge Tis bridge is used to measure capacitance - Schering bridge The peak current of a class A amplifier - Quiescent current In Rectifier diode, current is apprroximately by how much of an ac cycle - 180o The armature winding is connected to its own positive and negative terminals - Self excitation Configuration with highest amplification - Commin-emitter

70. Substance that generates voltage when exposed to light - Photovoltaic material 71. A two stage transistor amplifier in which the output collector of the first stage provides inpu to the emitter of the second stage. The final output is taken from the collector of the second or last stage. - Cascode configuration 72. The output on the first stage amplifier is connected on the base of the second stage amplifier. The configuration is - Cascade configuration 73. The power amplifier is connected using - Transformer coupling 74. It shows or displays and print the waveform of the transmitter and harmonics - Spectrum analyzer 75. It shows the wave for a long period of time - Storage oscilloscope 76. When the input of the op-amp is noisy - Change back and forth eratically between two states 77. A basic instrumentation amplifier is formed bt - 3 op-amps and 7 reistors 78. When triangular wave is the input of the integrator, what is the output? - Square wave 79. When severe arcing is noticeable in motor - During starting 80. The power dissipation of class C amplifier - Very low 81. Cross-over distortion is mainly problem of - Class B 82. Acoustic feedback in public address system - It serves no purpose 83. In op-amp the common mode voltage gain is 10 and the differential mode voltage gain is 20000, calculate the CMRR - 2000 84. In wein bridge oscillator posiive feedback circuit has - Lead lag circuit 85. In all the resistor combination which provides lesser noise in the op-amp - Make both feedback and input reistance as small as possible 86. When two inputs of the multiplier is connected together it operates as - Squaring circuit

87. Provides offset nulling - Zero output at error voltage 88. Damping factor at the filter is set by - Negative feedback circuit 89. In resonance, the resistance in common-base decrease will - Not affect the common-collector 90. Case of load regulator - When load changes the output voltage stays constant 91. UJT never has - Forward biased PN junction 92. In voltage divider bias npn transistor, the upper voltage divider resistor when open is - The transistor goes to cutoff 93. Most wires of the isolation amplifiers are connected at - Transformer 94. The ac generator is - By dc-generator supply to the dc-excitation to the rotating field 95. The operation of logarithmic amplifiers is based on - Logarithmically change of a PN junction 96. What term applies to the use of two or more generators to supply a common load? - Parallel operation/generators 97. Change in Input offset current due to temperatur change - Input offset current drift 98. The UJT has - A bilateral conduction 99. A DC motor - Is composed of armature winding and permanent magnet 100. Is a measure of an op-amps ability to reject common-mode inputs. - CMRR