Scribd
Upload
108 views1 page

Memory Erasing Procedure Guide

1. This document provides instructions for erasing the memory of a 7D1-40 transfer control system. 2. The procedure involves preparing short harness needles, turning off the ignition, accessing the transfer controller under the front left seat, and connecting the harnesses to reset the memory. 3. Before erasing memory, the document instructs to check that the actuator position detection harness and circuit are normal.

Uploaded by

Andrea Muñoz
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
108 views1 page

Memory Erasing Procedure Guide

1. This document provides instructions for erasing the memory of a 7D1-40 transfer control system. 2. The procedure involves preparing short harness needles, turning off the ignition, accessing the transfer controller under the front left seat, and connecting the harnesses to reset the memory. 3. Before erasing memory, the document instructs to check that the actuator position detection harness and circuit are normal.

Uploaded by

Andrea Muñoz
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

7D1-40 TRANSFER CONTROL SYSTEM

Memory erasing procedure


1. Prepare two pieces of short harness with the end sharped like a needle (bout 20cm(7.9 in) long). 2. Turn OFF the gnition. 3. Remove the front left seat ASM. 4. Make the controller under the front left seat ASM (spread the cut of the floor carpet).

5. Keeping the connector of the transfer controller connected, set the short harness from the back of the connector as illustrated. 6. Turn ON the gnition, wait for 2 seconds, and turn OFF the ignition after confirming the relay sound. 7. Disconnect the short harness, turn ON the ignition again, and confirm the "Check 4WD" lamp in the meter panel is OFF. 8. Before erasing the memory, check that the circuit of the T/F actuator position detection harness, etc. for t are normal.

Transfer Controller Pin Assignment

Axle Dummy

1_
IG N IND
LS2

1
TMt TM2 TM3

8'
+B

7
4L Out 4WD Axle Out M2 Axle M1 T/F M1 T/F M2 GND

Op SW Veo

Spd

LS1

ENG. Rev,

LS3

LS4

T/F Axle 4WD SW SW

N SW

Memory Memory clear dear lo

GND

Ope Check SW 4WD 4L IND GND IND

4H IND

20

19

18

17

16
A

15

14

13

12

11

14

13

12

11

10

You might also like