Scribd
Upload
314 views1 page

HV335T Firmware Update EN v1.0 PDF

The document provides instructions for updating the firmware on an HV335T device. It states that the install.img file should be copied to the root folder of a USB drive, which should then be connected to the device. The user should select "System Upgrade" in the home menu to start the 3-5 minute upgrade process, during which the device will reboot multiple times and reset settings to defaults upon completion.

Uploaded by

pedrojosebravo
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
314 views1 page

HV335T Firmware Update EN v1.0 PDF

The document provides instructions for updating the firmware on an HV335T device. It states that the install.img file should be copied to the root folder of a USB drive, which should then be connected to the device. The user should select "System Upgrade" in the home menu to start the 3-5 minute upgrade process, during which the device will reboot multiple times and reset settings to defaults upon completion.

Uploaded by

pedrojosebravo
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

HV335T Firmware Update

V1.0 Please follow the instruction below for ensuring a successful firmware update.

Upgrading Firmware
1. Save the install.img file to the root folder of an USB mass storage device. Note: 2. 3. 4. Do not copy the install.img file to a folder, else the update will not work.

Connect this device to a TV and then connect the USB mass storage device to this device. Press the STANDBY button on the remote control to activate this device.

Select Setup System System Upgrade in the Home Menu to perform upgrade. It may takes 3~5 minutes for the installation to complete. For a firmware update operation, the LED may blink during the installation process. Note: This device will automatically reboot several times to finish the installation. Do not turn it off during the installation process. This device will return to Home Menu after the firmware installation is completed. All settings in the Setup Menu will be set to default values after upgrade.

You might also like