Scribd
Upload
486 views

Automatic Active Phase Selector For Single Phase Load From Three Phase Supply Using Microcontroller 1

This document describes an automatic phase selector for a single phase load connected to a three phase power supply using a microcontroller. It detects when one of the three phases is absent and automatically switches the load to one of the remaining phases. The system continuously monitors the three phases and uses an LCD display to indicate which phase is currently powering the single phase load.

Uploaded by

ieee4mybusinessonly
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
486 views

Automatic Active Phase Selector For Single Phase Load From Three Phase Supply Using Microcontroller 1

This document describes an automatic phase selector for a single phase load connected to a three phase power supply using a microcontroller. It detects when one of the three phases is absent and automatically switches the load to one of the remaining phases. The system continuously monitors the three phases and uses an LCD display to indicate which phase is currently powering the single phase load.

Uploaded by

ieee4mybusinessonly
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

AUTOMATIC ACTIVE PHASE SELECTOR FOR SINGLE PHASE LOAD FROM THREE PHASE SUPPLY USING MICROCONTROLLER

ABSTRACT
Now a day's every system is automated in order to face new challenges. In the present days Automated systems have less manual operations, flexibility, reliability and accurate. Due to this demand every field prefers automated control systems. Especially in the field of electronics automated systems are giving good performance. Generally common problem for 3 phase supply is absence of one of any of the phase. So, in this Project, we are using 3 phase supply i.e.., R-, Y-, B- are the three single phase supplys which are used to put some load continuously when any one of the 3-phase supply has gone the other are ready to give supply to single phase load and LCD is ready to display which phase in working condition.

BLOCK DIAGRAM

You might also like