Tuning anapole resonator question

  • Thread starter Thread starter yefj
  • Start date Start date
yefj
Messages
56
Reaction score
2
Hello , I have designed an anapole resonator which works great at 10GHZ,With the mode shown below.
However when I try to increase the frequency of this mode by decreasing the inner circle it didnt went so well.
Video is attached ,could you please help me understand how to increase the frequency of this mode and increase its coupling?
Thanks.
2025-08-20 10-19-52.mkv
1755675116827.webp

1755675091144.webp

1755675064194.webp
 
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
Thread 'Digital phase converters for running 3-phase motors'
To be clear, I’m not asking about variable frequency drives (VFDs, inverter drives). These rectify the 1-phase onto a DC bus, then use PWM to generate three phases 120deg apart. They can vary the output frequency. DPCs, also (I think) called digital phase shifters, apparently feed the 1-phase straight through, and generate a third leg from a DC bus electronically. Their output frequency is fixed to whatever the input is. I can’t see how they approximate real 3-phase - the mains input...
Back
Top