25XX Product Family of ONTs Module 6
Marcelo Sena/Pablo Guevara December 2011
PROPRIETARY & CONFIDENTIAL
25XX Product Family of ONTs
General information
All of the indoor ONTs use the Broadlight 234x chipset
2345 has no voice DSP
2348 has integrated voice DSP supporting up to 4 calls. Separate binaries for different voice protocol stacks
SIP
H.248 Not all models use the same power supply. Be sure the power supply matches the ONT model. The power requirements range from 1.0A to 2.0A for the indoor residential and small business models.
PROPRIETARY & CONFIDENTIAL
Serial Numbers
There are two important serial numbers on these products. The product serial number is what Zhone uses to track the product. The PON serial number, or FSAN serial number, is what the OLT will see when the ONT ranges. Zhone tracks both serial numbers. The product serial number should be used for RMAs.
PROPRIETARY & CONFIDENTIAL
Serial number placement
Similar placement on the 2501, 2504, 2510A, 2520
Product S/N
PON S/N
PROPRIETARY & CONFIDENTIAL
Serial number placement
Similar placement on the 2511, 5114, 5120
Product S/N PON S/N
PROPRIETARY & CONFIDENTIAL
Comon Specs
Interfaces GPON: SC/APC Connector 1.244Gbps Burst Mode Upstream Transmitter (1310nm) 2.488Gbps Downstream Receiver (1490nm) Voice Support 5 REN per line, balanced Ring at 55V RMS, DTMF dialing Multiple voice codec - G.711 (u/a-law), G.726, G.729 (A and B), G.723.1 T.30 and T.38 Fax GPON Fully ITU-T G.984 compliant framing Multiple T-CONTs per device Multiple GEM Ports per device Support Single T-CONT mode and Multiple T-CONTs mode Flexible mapping between GEM Ports and T-CONT Activation with automatic discovered SN and password in conformance with ITU-T G.984.3 AES-128 Decryption with key generation and switching FEC (Forward Error Correction) 802.1p mapper service profile on U/S Mapping of GEM Ports into a T-CONT with priority queues based scheduling Support for Multicast GEM Port Standards Support
Echo Canceling, VAD, CNG
Various CLASS services - Caller ID, Call Waiting, Call Forwarding, Call Transfer, etc. SIP (RFC3261), MEGACO v2 (H.248)
ITU-T G.984 compliant
PROPRIETARY & CONFIDENTIAL
Comon Specs cont.
Ethernet / IP Bridging and switching (802.1D / 802.1 Q) Four traffic classes with 802.1p 802.3n flow control Up to 512 MAC address entries VLAN tagging / untagging VLAN stacking (Q-in-Q) MAC limiting 802.1x Ethernet Authentication PPPoE client IPTV IGMP multicast IGMP snooping Bandwidth/Distance Compliant with ITU-T G.984.2 Amd1, Class B+ APD receiver and DFB transmitter -0.5~+5dBm launch power, -27 dBm sensitivity, and -8dBm overload Regulatory Compliance CE (ETSI) Operating Requirements Operating Temperature: -5C to 45C Operating Humidity: 5% - 90% non condensing Storage Temperature: -20C to 60C Storage Humidity: 5% - 95% non condensing
Power
Input: 110/240V AC Adaptor (12 VDC) Power Consumption: 8-12W Dying Gasp Support Management OMCI complies with G.984.4
PROPRIETARY & CONFIDENTIAL
2510
2510A 4FE + 2POTS First version of basic ONT with VoIP support This ONT is no longer shipping 2510A is the direct replacement Last software version for 2510 R2.0.9.19A Newer code can not be loaded to the 2510
PROPRIETARY & CONFIDENTIAL
2510A
2510A 4FE + 2POTS Same interfaces as 2510 ONT Improved performance The default IP (LAN side) is [Link]
PROPRIETARY & CONFIDENTIAL
10
2511
2511 4FE + 2POTS + RF Uses BL2348 with no external switch chip Ships with a fiber tray
225 mm
The default IP (LAN side) is [Link]
268 mm
137 mm 188 mm
PROPRIETARY & CONFIDENTIAL
11
Fiber tray wire management
Three examples of wire management using the detachable fiber tray.
PROPRIETARY & CONFIDENTIAL
12
Wire Management
The ONTs that ship with a fiber tray can also support fiber management without the tray. This figure shows fiber management using the bottom of the ONT.
PROPRIETARY & CONFIDENTIAL
13
2543
Same as 2511 Smaller form factor Same specs GE instead of FE ports
Uses the same software as the 2511
PROPRIETARY & CONFIDENTIAL
14
OMCI
The 25XX ONT series are configured using Operation, Management, and Control Interface (OMCI) which is defined in ITU-T G.983 and G.984. The MXK OLT sends configuration down to the ONU ONU do not store configuration information. Every boot requires configuration from the OLT OMCI only works between OLT and ONU. Does not work over multiple hops. OMCI is bidirectional. The ONU reports alarms and statistics to the OLT using OMCI.
The Management Entity (ME) in OMCI is similar to a MIB in SNMP.
Zhone calls the file loaded into the MXK the ME file because it is made up of our variables and many MEs.
PROPRIETARY & CONFIDENTIAL
15
OMCI Configuration Web Tool
[Link] Only the ONT models that have passed testing are listed on this site.
PROPRIETARY & CONFIDENTIAL
16
VLAN GEM UNI Mapping
PROPRIETARY & CONFIDENTIAL
17
MAC Table Size
All models - 512 total on all models 256 used for unicast 256 used for multicast
PROPRIETARY & CONFIDENTIAL
18
Reg Id
Ativacao do Reg. ID na ONT Conectar o cabo de forca para energizar a ONT. Desconectar a interface PON se estiver conectada, conectar um aparelho telefonico na primeira porta POTS da ONT. Pressionar o botao de reset da ONT por 5 segundos. Esperar ate que o LED POTS da ONT comece a piscar ( 0.7 segundos ligado, e 0.7 segundos desligado). Retire o monofone do telefone para fora do gancho. Ativar o tom de discar executando as seguintes funcoes: * Para ASCII SLID/Password, discar "*0": * Para Hexadecimal SLID/Password, discar "*1": Esses numeros podem ser modificados em um outro firmware. Depois do tom de discar, disque o valor SLID executando um dos seguintes passos: * Para ASCII - SLID/Password, discar duas vezes a SLID/Password, suporta ate 10 digitos com "#" finalizando em cada vez. As duas passwords (senhas) dever ser a mesma. Somente digitos de 0 a 9 sao aceitos. * Para Hexadecimal, discar duas vezes a senha ate 20 digitos com # finalizando em cada vez. As duas senhas devem ser a mesma. Somente digitos 0 to 9 e "*1" ate "*6" sao aceitos. "*1" a "*6" represents "A" to "F".
Nota: Na versao corrente, as senhas hexadecimais s somente aceitam 30 ~39 (ex:. ASCII de 0 a 9).
8. Se o tom de ocupado for ouvido, a SLID/Password nao foi aceita. Coloque o monofone no gancho e volte ao passo 4. 9. Se o tom de discar for ouvido, a SlID/Password foi aceita. Coloque o monofone no gancho para sair do modo de provisionamento da SLID/Password. 10. Rebote a ONT 11. O procedimento foi completado com sucesso e a ONT pode ser inserida na fibra para ocorrer a insercao automatica na ONT designado no item 1) pelo ZMS ou atraves do comando de linha.
OBS: Para a insercao do REg ID na ONT, e necessario que a ONT tenha um firmware que suporte essa funcao.
PROPRIETARY & CONFIDENTIAL
19
ONT 25xx Management Telnet/WebGUI
User: root Password: admin - Management Web GUI CLI OMCI
PROPRIETARY & CONFIDENTIAL
20
ONT 25xx Management - LAN
PROPRIETARY & CONFIDENTIAL
21
ONT 25xx Management - WAN
PROPRIETARY & CONFIDENTIAL
22