Scribd
Upload
31 views2 pages

ECM Programming Course Overview

The document outlines the course content for an ECM (Engine Control Module) training program at BABA Automobile Jaipur Pvt Ltd. It includes topics such as basic electrical concepts, ECM components, soldering techniques, programming tools, and various testing methods over a span of 30 days. Each topic is assigned specific days for coverage and hands-on practice.

Uploaded by

Aryan Kardam
Copyright
© All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
31 views2 pages

ECM Programming Course Overview

The document outlines the course content for an ECM (Engine Control Module) training program at BABA Automobile Jaipur Pvt Ltd. It includes topics such as basic electrical concepts, ECM components, soldering techniques, programming tools, and various testing methods over a span of 30 days. Each topic is assigned specific days for coverage and hands-on practice.

Uploaded by

Aryan Kardam
Copyright
© All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd

BABA AUTOMOBILE JAIPUR PVT LTD

ECM COURSE CONTENT


NAME:-
CONTACT NO:-
[Link] Topic Days Convered Sign
1. Basic Electrical
Voltage (AC & DC) Current (AC & DC) DAY-1
Power, Frequency etc

2. Multimeter (Working & Testing) DAY-1

3. ECM Components DAY-1


Resistance (Type, Working, Testing) DAY-2
Capacitor (Type, Working, Testing) DAY-2
Diode (Type, Working, Testing) DAY-2
Transistor (Type, Working, Testing) DAY-3
MOSFET (Type, Working, Testing) DAY-3
Rellay (Type, Working, Testing) DAY-4
Voltage Regulator IC (Type, Working, Testing) DAY-4
Crystal Oscillator (Type, Working, Testing) DAY-5
Inductor Coil (Type, Working, Testing) DAY-5
Opto coupler (Type, Working, Testing) DAY-5

4. Soldering & Desoldering of ECM component DAY-6

5. Conversion of 220 VAC to 12V DC/5V DC using DAY-9


VR IC

6. ECM Tracing & Tracking DAY-10

7. Power IC (Working & Pinouts) DAY-13

8. System IC (Working & Pinouts) DAY-13

9. Injector Section (Working & Tracing) DAY-14

10. MCU Section (Processor Types & pinouts) DAY-15

11. ECM file read & write using programming tool DAY-16-18

KTAG Programming tool


KTM Bench programming tool
KESS V2 programming tool
Red UPA programming tool
KT-200 programming tool

12. On table ECM testing using CAN box DAY-19-20

13. EPS tracing DAY-20


Meter Repairing & testing DAY-21

14. KEY & Remote Clonning using VVDI tool DAY-24-25

15. Sensors (Types, working, wiring, testing) DAY-26-27

16. Sensors testing on working car DAY-28-29

17. Car scanning by different scanner DAY-30

You might also like