Scribd
Upload
34 views2 pages

Static Routing Lab

This document provides instructions for configuring static routing in a small network. It describes: - The advantages of static routing including ease of implementation and security, but it is only suitable for small networks and cannot reroute if a link fails. - How to assign IP addresses to router interfaces, including entering interface configuration mode and using the "ip address" command. - How to configure static routes using the "ip route" command, specifying the destination network, subnet mask, and next hop neighbor IP address. - Checking the routing tables with the "show ip route" command to confirm static routes are added.

Uploaded by

pacific flightshk
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views2 pages

Static Routing Lab

This document provides instructions for configuring static routing in a small network. It describes: - The advantages of static routing including ease of implementation and security, but it is only suitable for small networks and cannot reroute if a link fails. - How to assign IP addresses to router interfaces, including entering interface configuration mode and using the "ip address" command. - How to configure static routes using the "ip route" command, specifying the destination network, subnet mask, and next hop neighbor IP address. - Checking the routing tables with the "show ip route" command to confirm static routes are added.

Uploaded by

pacific flightshk
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

STATIC ROUTING LAB

Advantage of static routing

 It is easy to implement.
 It is most secure way of routing, since no information is shared with other routers.
 It puts no overhead on resources such as CPU or memory.

Disadvantage of static routing

 It is suitable only for small network.


 If a link fails it cannot reroute the traffic.

STEP 1 - Assign IP address to interfaces of routers

Two interfaces Ethernet and Ethernet of each Router are used in this topology. By default
interfaces on router are remain administratively down during the start up.

We need to configure IP address and other parameters on interfaces before we could


actually use them for routing. Interface mode is used to assign IP address and other
parameters. Interface mode can be accessed from global configuration mode. Following
commands are used to access the global configuration mode.

Router>enable
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
From global configuration mode we can enter in interface mode. From there we can
configure the interface. Following commands will assign IP address on Ethernet0/0.

Router(config)#interface Ethernet 0/1


Router(config-if)#ip address 10.X.Y.1 [Link]
Router(config-if)#no shutdown
Router(config-if)#exit
Router(config)#

Use show ip interface brief to confirm the interface has an IP address and interface status is
up and up

There are two types of routing static and dynamic. In this lab we will use static method of
routing.
Step 2- configure the static route

Syntax of static routing

Router(config)# ip route destination_network_# [subnet_mask]


IP_address_of_next_hop_neighbor

By default when a packet arrives in interface, router checks destination filed in packet and
compare it with routing table. If it finds a match for destination network then it will forward
that packet from related interface. If it does not find a match in routing table then it will
discard that packet. This is the default behavior of router.

We do not need to configure directly connected networks.

Run following command from global configuration mode in routers.

RouterXY
RouterXY(config)#ip route 10.X.Y.0 [Link] 10.X.Y.1
This command instructs router that when you receive a packet for 10.X.Y.0 network give
it to [Link]. Network [Link] is directly connected so we do not need to configure
it here.

STEP 3- Check routing Tables of Routers:

RouterXP#show ip route

You might also like