(605704-H)
CERTIFIED SOLIDWORKS PROFESSIONAL (CSWP)
Duration : 3 hours 30 minutes
Each Duration Segment 1 : 90 minute
Segment 2 : 40 minute
Segment 3 : 80 minute
Methodology : Practical hands-on and case studies.
Target SolidWorks Users
: R&D engineer
Application engineer
Product designer or engineer
Industrial engineer
Objective : SolidWorks Certifications can be used as a benchmark to measure your knowledge and
competency with SolidWorks software.
A Certified SolidWorks Professional is an individual that has successfully passed our
advanced skills examination.
Each CSWP has proven their ability to design and analyze parametric parts and moveable
assemblies using a variety of complex features in SolidWorks.
Recommended : To ensure a consistent learning experience for all students, participants should have:
Training
Attended SolidWorks Essentials
Attended Advanced Assembly Modeling
Attended Advanced Part Modeling
Passing Grade : Minimum 75% in each Segment
Rewards : Electronics Certificate
An International recognized certificate
CSWP business card LOGO
Certification Directory / Portal
Re-test Policy : There is a minimum 14 day waiting period between every attempt of the same CSWP
Segment exam.
PETALING JAYA PENANG JOHOR
22A, Jalan PJS 1/46 68A, Jalan Perai Jaya 4 11-A, Jalan Jati 2,
46150 Petaling Jaya 13700 Prai Taman Nusa Bestari Jaya
Selangor Penang 79150, Johor
Tel: + 60 3 7783 6866 Tel : + 60 4 399 5571 Tel: + 60 7 512 7978
Fax: + 60 3 7781 1185 Fax : + 60 4 399 5572 Fax: + 60 7 512 2162
1300-88-2797 | training@[Link] | [Link]
(605704-H)
Exam features hands-on challenges in these areas:
Segment 1: (90 Minutes)
Creating a part from a drawing
Using linked dimensions and equations to aid in modeling
Using equations to relate dimensions
Updating parameters and dimension sizes
Mass property analysis
Modifying geometry on initial part to create a more complex part
Segment 2: (40 Minutes)
Creating configurations from other configurations
Changing configurations
Mass properties
Changing features of an existing SolidWorks part
Creation and modification of a Design Table in an existing part
Segment 3: (80 Minutes)
Creating an assembly
Adding parts to an assembly
Doing collision detection when moving a part in an assembly
Mates
Replacing a part with another part in an assembly
Creating a coordinate system
Using a coordinate system to perform mass properties analysis
PETALING JAYA PENANG JOHOR
22A, Jalan PJS 1/46 68A, Jalan Perai Jaya 4 11-A, Jalan Jati 2,
46150 Petaling Jaya 13700 Prai Taman Nusa Bestari Jaya
Selangor Penang 79150, Johor
Tel: + 60 3 7783 6866 Tel : + 60 4 399 5571 Tel: + 60 7 512 7978
Fax: + 60 3 7781 1185 Fax : + 60 4 399 5572 Fax: + 60 7 512 2162
1300-88-2797 | training@[Link] | [Link]
