Scribd
Upload
959 views2 pages

Per Unit System Calculations Guide

This document discusses per unit calculations which are used to quantify equipment parameters relative to their nameplate ratings. It provides the standard base quantities used for per unit analysis of an entire power system, with the voltage base typically being the nominal voltage rating and power base of 100 MVA. The bases for current and impedance can then be calculated from the power and voltage bases using Ohm's law.

Uploaded by

Osman Şen
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
959 views2 pages

Per Unit System Calculations Guide

This document discusses per unit calculations which are used to quantify equipment parameters relative to their nameplate ratings. It provides the standard base quantities used for per unit analysis of an entire power system, with the voltage base typically being the nominal voltage rating and power base of 100 MVA. The bases for current and impedance can then be calculated from the power and voltage bases using Ohm's law.

Uploaded by

Osman Şen
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

ECE 4501

POWER SYSTEMS

UMD

PER UNIT IDENTITIES


DISCUSSION:
Per Unit (pu) systems are used by engineers to quantify equipment parameters in terms of their Nameplate Ratings. For example, a motor with a 100 Horsepower (HP) nameplate rating which delivers 90 HP to a dynamic load is said to be 90% loaded or 0.9 per unit. In this case, the per unit base is the nameplate horsepower rating of 100. When the motor delivers 90 HP, 90/100 equals 0.9 per unit. In general then, Per Unit = Present Value Base Value

Any piece of equipment can be per unitized using its nameplate ratings for Voltage, Current and Power (in Volt-Amperes). In a more generalized approach for power systems containing many pieces of equipment, there are standard base quantities for per unit calculations. These become useful when performing calculations across a power system where multiple voltage levels and different equipment sizes occur. In the most common usage for per unit calculation, the analysis of an entire power system, the nominal or nameplate voltage rating for each voltage level of the system is chosen as base voltage. In such analysis, the power base is often chosen as 100 MVA and bases for current and impedance are calculated using the power and voltage base. By the use of Ohms law, selecting any two base values, such as voltage and power, allows the calculation of the other two bases.

Calculation of Per Unit Base Values:

BASE Quantity
POWER* VOLTAGE

Single-Phase Systems
Sbase 1 = Vbase x Ibase
Base Voltage is almost always known. Use the nameplate or nominal rating for the equipment or system. Otherwise, Vbase = Sbase 1

Three-Phase Systems
Sbase 3 = 3 Vbase x Ibase
Same comment as Single-Phase. Otherwise, Vbase L-L =
(where Vbase is a Line-to-Line value)

Sbase 3 3 Ibase

CURRENT IMPEDANCE

Ibase

Ibase = Zbase
OR

Sbase1 Vbase = Vbase2 Sbase1 Vbase Ibase

Ibase =

Sbase3 3 Vbase L-L

Zbase =

Zbase = (Vbase L-L)2 Sbase 3

* - Base Power is traditionally Apparent Power, S. Real Power, P, can also be used (with care).
Per Unit Impedance: Zpu = Z (in Ohms) Zbase Converting from one base to another: Zpu (New) = Zpu (old) [Vbase (old) ]2 Sbase (new) ---------------------------[Vbase (new) ]2 Sbase (old)

You might also like