Scribd
Upload
519 views1 page

Throttle Body Removal for 2001 Explorer

This document provides instructions for removing and installing the throttle body on a 2001 Ford Explorer Sport Trac with a 4.0L V6 engine. The procedure involves disconnecting the air cleaner outlet tube, throttle position sensor connector, accelerator and speed control cables before removing the throttle body. When installing, the procedure is reversed and a new throttle body gasket must be used. Safety warnings are provided to avoid potential fire hazards when working on fuel system components.

Uploaded by

Michael Hernandez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
519 views1 page

Throttle Body Removal for 2001 Explorer

This document provides instructions for removing and installing the throttle body on a 2001 Ford Explorer Sport Trac with a 4.0L V6 engine. The procedure involves disconnecting the air cleaner outlet tube, throttle position sensor connector, accelerator and speed control cables before removing the throttle body. When installing, the procedure is reversed and a new throttle body gasket must be used. Safety warnings are provided to avoid potential fire hazards when working on fuel system components.

Uploaded by

Michael Hernandez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

2001 Ford EXPLORER SPORT TRAC

Submodel: | Engine Type: V6 | Liters: 4.0


Fuel Delivery: FI | Fuel: GAS

SECTION 303-04: Fuel Charging and Controls 4.0L SOHC 2001 Explorer Sport/Sport Trac Workshop Manual
REMOVAL AND INSTALLATION Procedure revision date: 06/23/2000
Throttle Body
Removal and Installation
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are
always present and may be ignited. Failure to follow these instructions may result in personal injury.
CAUTION: Throttle body bore and plate area have a special coating and cannot be cleaned, or possible damage to the throttle body may occur.
1. Remove the air cleaner outlet tube. For additional information, refer to Section 303-12.
2. Disconnect the throttle position (TP) sensor electrical connector.
3. Disconnect the accelerator cable and the speed control cable (if equipped).
4. Remove the throttle body.
Discard the gasket.
5. To install, reverse the removal procedure.

You might also like